SC403BEVB 查看數據表（PDF） - Semtech Corporation

零件编号

产品描述 (功能)

生产厂家

SC403BEVB

6A EcoSpeed® Integrated FET Regulator with Programmable LDO

Semtech Corporation 

SC403B

Applications Information (continued)

IPEAK

ILOAD

ILIM

Time

Figure 7 — Valley Current Limit

Setting the valley current limit to 6A results in a peak induc-

tor current of 6A plus the peak-to-peak ripple current. In

this situation, the average (load) current through the induc-

tor is 6A plus one-half the peak-to-peak ripple current.

is the soft start time (tSS). The calculation for the soft-start

time is shown by the following equation.

t SS

CSS

u

1.5V

3PA

The voltage at the SS pin continues to ramp up and eventu-

ally is equal to 64% of VDD. After soft start completes, the FB

pin voltage is compared to the internal reference. The delay

time between the VOUT regulation point and PGOOD going

high is shown by the following equation.

tPGOOD-DELAY

CSS u (0.64 u VDD  1.5V)

3PA

The internal 10μA current source is temperature compen-

sated at 4100ppm in order to provide tracking with the

RDSON.

The RILIM value is calculated by the following equation.

RILIM = 1176 x ILIM x [0.088 x (5V - VDD) + 1] (Ω)

where ILIM is in Amps.

When selecting a value for RILIM do not exceed the absolute

maximum voltage value for the ILIM pin. Note that because

the low-side MOSFET with low RDSON is used for current

sensing, the PCB layout, solder connections, and PCB connec-

tion to the LX node must be done carefully to optimize opera-

tion. RILIM should be connected directly to LXS (pin 28).

Soft-Start of PWM Regulator

SC403B has a programmable soft-start time that is con-

trolled by an external capacitor at the SS pin. After the

controller meets both UVLO and EN/PSV thresholds, the

controller has an internal current source of 3µA flowing

through the SS pin to charge the capacitor. During the

start up process (Figure 8), a percentage of the voltage at

the SS pin is used as the reference for the FB comparator.

The percentage is 50% for the SC403 and 40% for the

SC403B. The PWM comparator issues an on-time pulse

when the voltage at the FB pin is less than 50% (or 40%) of

the SS pin. As result, the output voltage follows the SS

start voltage. The output voltage reaches and maintains

regulation when the soft start voltage is > 1.5V. The time

between the first LX pulse and when VOUT meets regulation

(10mV/div)

(500mV/div)

(2V/div)

(5V/div)

Time (400µ��/d��iv��)s�����

Figure 8 — Soft-start Timing Diagram

Pre-Bias Startup

SC403B can start up as if in a soft-start condition with an

existing output voltage level. The soft start time is still the

same as normal start up (when the output voltage starts

from zero). The output voltage starts to ramp up when

40% of the voltage at SS pin meets the pre-charge FB

voltage level. Pre-bias startup is achieved by turning off

the lower gate when the inductor current falls below zero.

This method prevents the output voltage from

decreasing.

Power Good Output

The PGOOD (power good) output is an open-drain output

which requires a pull-up resistor. When the voltage at the

FB pin is 10% below the nominal voltage, PGOOD is pulled

low. It is held low until the output voltage returns above

92% of nominal.

19

Share Link: