EVSPIN32G4 数据手册 ( 数据表 ) - STMicroelectronics

Description
   The EVSPIN32G4 is a demonstration board based on the STSPIN32G4 system in package and STL110N10F7 power MOSFETs. The STSPIN32G4 integrates in a 9x9 mm VFQFPN package, a triple high-performance half-bridge gate driver with a rich set of programmable features and one mixed signal STM32G431 microcontroller.

FEATUREs
• Input bus voltage from 10 V to 75 V with dedicated monitoring
• Power stage based on the STL110N10F7 power MOSFETs with output current
   up to 20 Arms (with heatsink mounted) and protected to overcurrent conditions
• STSPIN32G4, high performance three-phase motor controller with embedded
   STM32G431 MCU:
   – 32-bit ARM® Cortex®-M4 MCU+FPU
   – Up to 170 MHz clock frequency
   – CORDIC mathematical hardware accelerator for trigonometric functions
   – 128 kB Flash memory with proprietary code readout protection (PCROP),
      securable memory area, 1 kB OTP
   – 32 kB SRAM memory with HW parity check
   – 2 x advanced timers for motor control, 16-bit with up to 6 x PWM channels
      each
   – 8 x general purpose timers
   – 2 x ADCs 12-bit resolution (up to 19 channels) with 4 Msps conversion rate
   – 4 x 12-bit DAC channels
   – 4 x ultra-fast rail-to-rail comparators
   – 3 x rail-to-rail operational amplifiers usable also in PGA mode
   – Internal high precision voltage reference
   – Up to 40 GPIOs
   – Full set of interfaces: I2C, SPI, UART and CAN
   – VCC buck converter up to 200 mA, with programmable output and
      embedded MOSFET
   – 3.3 V LDO linear regulator up to 150 mA
   – Low quiescent linear regulator for MCU supply in standby mode
   – Regulators with full set of protection features; thermal shutdown, 
      short-circuit and overload protections
   – 75 V rated gate drivers with 1 A sink/source current and embedded
      bootstrap diodes
   – Drain-source voltage sensing of each power MOSFET
• Three-shunt or single-shunt configurable current sensing
• Digital Hall sensor and quadrature encored input
• ST-LINK/V2 programmer and debugger
• Arduino UNO connector
• Predisposition for CAN bus
• NTC sensor for power stage temperature monitoring

APPLICATION
• Industrial and home automation
• Home appliances such as vacuum cleaners, dryers and cleaning robots
• Servo drives and e-bikes
• Service and automation robots
• Power and garden tools
• Pumps and fans
• Drones and aeromodelling