STM32F100V6H6BTR 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

STM32F100V6H6BTR

Low & medium-density value line, advanced ARM®-based 32-bit MCU with 16 to 128 KB Flash, 12 timers, ADC, DAC & 8 comm interfaces

STMicroelectronics 

Electrical characteristics

STM32F100x4, STM32F100x6, STM32F100x8, STM32F100xB

5.3.10

EMC characteristics

Susceptibility tests are performed on a sample basis during device characterization.

Functional EMS (Electromagnetic susceptibility)

While a simple application is executed on the device (toggling 2 LEDs through I/O ports).

the device is stressed by two electromagnetic events until a failure occurs. The failure is

indicated by the LEDs:

• Electrostatic discharge (ESD) (positive and negative) is applied to all device pins until

a functional disturbance occurs. This test is compliant with the IEC 61000-4-2 standard.

• FTB: A Burst of Fast Transient voltage (positive and negative) is applied to VDD and

VSS through a 100 pF capacitor, until a functional disturbance occurs. This test is

compliant with the IEC 61000-4-4 standard.

A device reset allows normal operations to be resumed.

The test results are given in Table 29. They are based on the EMS levels and classes

defined in application note AN1709.

Table 29. EMS characteristics

Symbol

Parameter

Conditions

VFESD

VEFTB

Voltage limits to be applied on any I/O pin to

induce a functional disturbance

VDD = 3.3 V, TA = +25 °C,

fHCLK = 24 MHz, LQFP100

package, conforms to

IEC 61000-4-2

Fast transient voltage burst limits to be

applied through 100 pF on VDD and VSS pins

to induce a functional disturbance

VDD = 3.3 V, TA = +25 °C,

fHCLK = 24 MHz, LQFP100

package, conforms to

IEC 61000-4-4

Level/Class

2B

4A

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user applies EMC software optimization and pre

qualification tests in relation with the EMC level requested for his application.

Software recommendations

The software flowchart must include the management of runaway conditions such as:

• Corrupted program counter

• Unexpected reset

• Critical Data corruption (control registers...)

Prequalification trials

Most of the common failures (unexpected reset and program counter corruption) can be

reproduced by manually forcing a low state on the NRST pin or the Oscillator pins for 1

second. To complete these trials, ESD stress can be applied directly on the device, over the

range of specification values. When unexpected behavior is detected, the software can be

hardened to prevent unrecoverable errors occurring (see application note AN1015).

54/96

DocID16455 Rev 9

Share Link: