M45PE10-VMN6TP 查看數據表（PDF） - Numonyx -> Micron

零件编号

产品描述 (功能)

生产厂家

M45PE10-VMN6TP

1-Mbit, page-erasable serial flash memory with byte-alterability and 75 MHz SPI bus interface

Numonyx -> Micron 

M45PE10

Instructions

6.12

Release from deep power-down (RDP)

Once the device has entered the deep power-down mode, all instructions are ignored

except the release from deep power-down (RDP) instruction. Executing this instruction

takes the device out of the deep power-down mode.

The release from deep power-down (RDP) instruction is entered by driving Chip Select (S)

Low, followed by the instruction code on Serial Data input (D). Chip Select (S) must be

driven Low for the entire duration of the sequence.

The instruction sequence is shown in Figure 17.

The release from deep power-down (RDP) instruction is terminated by driving Chip Select

(S) High. Sending additional clock cycles on Serial Clock (C), while Chip Select (S) is driven

Low, cause the instruction to be rejected, and not executed.

After Chip Select (S) has been driven High, followed by a delay, tRDP, the device is put in the

Standby Power mode. Chip Select (S) must remain High at least until this period is over. The

device waits to be selected, so that it can receive, decode and execute instructions.

Any release from deep power-down (RDP) instruction, while an erase, program or write

cycle is in progress, is rejected without having any effects on the cycle that is in progress.

Figure 17. Release from deep power-down (RDP) instruction sequence

S

01234567

tRDP

C

Instruction

D

High Impedance

Q

Deep power-down mode Standby mode

AI06807

31/47

Share Link: