CS1880-IB 查看數據表（PDF） - Cirrus Logic

零件编号

产品描述 (功能)

生产厂家

CS1880-IB

Octal E1 Line Interface Unit

Cirrus Logic 

CS61880

11. JITTER ATTENUATOR

The CS61880 internal jitter attenuators can be

switched into either the receive or transmit paths.

Alternatively, it can be removed from both paths to

reduce the propagation delay.

During Hardware mode operation, the location of

the jitter attenuator for all eight channels are con-

trolled by the JASEL pin (Refer to Table 7 for pin

configurations). The jitter attenuator’s FIFO length

and corner frequency, can not be changed in hard-

ware mode. The FIFO length and corner frequency

are set to 32 bits and 1.25 Hz.

Table 7. Jitter Attenuator Configurations

PIN STATE

LOW

HIGH

OPEN

JITTER ATTENUATOR POSITON

Transmit Path

Receive Path

Disabled

During host mode operation, the location of the jit-

ter attenuator for all eight channels are set by bits 0

and 1 in the Line Length Channel ID Register

(10h) (See Section 14.17 on page 38). This register

(0Fh) also configures the jitter attenuator’s FIFO

length (bit 3) and corner frequency (bit 2).

The attenuator consists of a 64-bit FIFO, a narrow-

band monolithic PLL, and control logic. The jitter

attenuator requires no external crystal. Signal jitter

is absorbed in the FIFO which is designed to nei-

ther overflow nor underflow.

If overflow or underflow is imminent, the jitter

transfer function is altered to ensure that no bit-er-

rors occur. A configuration option is provided to

reduce the jitter attenuator FIFO length from 64

bits to 32 bits in order to reduce propagation delay.

The jitter attenuator -3 dB knee frequency depends

on the settings of the Jitter Attenuator FIFO length

and the Jitter Attenuator Corner Frequency, bits 2

and 3, in the Line Length Channel ID Register

(10h) (See Section 14.17 on page 38)). Setting the

lowest corner frequency guarantees jitter attenua-

tion compliance to European specifications TBR

12/13 and ETS 300 011. The jitter attenuator is also

compliant with ITU-T G.735, G.742, and G.783

(Refer to Figure 18 on page 56 and Figure 19 on

page 57).

28

DS450PP2

Share Link: