CS4385
5. REGISTER DESCRIPTION
Note: All registers are read/write in I2C mode and write only in SPI, unless otherwise noted.
5.1 Chip Revision (address 01h)
7
PART4
0
6
PART3
0
5
PART2
0
4
PART1
0
5.1.1 PART NUMBER ID (PART) [READ ONLY]
00001- CS4385
3
PART0
1
2
REV2
-
1
REV1
-
REVISION ID (REV) [READ ONLY]
000 - Revision A
Function:
This read-only register can be used to identify the model and revision number of the device.
0
REV0
-
5.2 Mode Control 1 (address 02h)
7
CPEN
0
6
FREEZE
0
5
DSD/PCM
0
4
DAC4_DIS
0
3
DAC3_DIS
0
2
DAC2_DIS
0
1
DAC1_DIS
0
0
PDN
1
5.2.1 CONTROL PORT ENABLE (CPEN)
Default = 0
0 - Disabled
1 - Enabled
Function:
This bit defaults to 0, allowing the device to power-up in Stand-Alone mode. The Control port mode
can be accessed by setting this bit to 1. This will allow the operation of the device to be controlled by
the registers and the pin definitions will conform to Control Port Mode. To accomplish a clean power-
up, the user should write this bit within 10 ms following the release of Reset.
DS671A1
37