STM32F030C8P6TR(2013) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

STM32F030C8P6TR
(Rev.:2013)

Value-line ARM®-based 32-bit MCU with up to 256-KB Flash, timers, ADC, communication interfaces, 2.4-3.6 V operation

STMicroelectronics 

STM32F030x4 STM32F030x6 STM32F030x8

Electrical characteristics

Functional EMS (electromagnetic susceptibility)

While a simple application is executed on the device (toggling 2 LEDs through I/O ports).

the device is stressed by two electromagnetic events until a failure occurs. The failure is

indicated by the LEDs:

 Electrostatic discharge (ESD) (positive and negative) is applied to all device pins

until a functional disturbance occurs. This test is compliant with the IEC 61000-4-2

standard.

 FTB: A Burst of Fast Transient voltage (positive and negative) is applied to VDD and

VSS through a 100 pF capacitor, until a functional disturbance occurs. This test is

compliant with the IEC 61000-4-4 standard.

A device reset allows normal operations to be resumed.

The test results are given in Table 39. They are based on the EMS levels and classes

defined in application note AN1709.

Table 39. EMS characteristics

Symbol

Parameter

Conditions

Level/

Class

VFESD

Voltage limits to be applied on any I/O pin to

induce a functional disturbance

VDD 3.3 V, LQFP64, TA +25 °C,

fHCLK 48 MHz

conforms to IEC 61000-4-2

2B

VEFTB

Fast transient voltage burst limits to be

applied through 100 pF on VDD and VSS

pins to induce a functional disturbance

VDD3.3 V, LQFP64, TA +25 °C,

fHCLK 48 MHz

3B

conforms to IEC 61000-4-4

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user applies EMC software optimization and

prequalification tests in relation with the EMC level requested for his application.

Software recommendations

The software flowchart must include the management of runaway conditions such as:

 Corrupted program counter

 Unexpected reset

 Critical Data corruption (control registers...)

Prequalification trials

Most of the common failures (unexpected reset and program counter corruption) can be

reproduced by manually forcing a low state on the NRST pin or the Oscillator pins for 1

second.

To complete these trials, ESD stress can be applied directly on the device, over the range of

specification values. When unexpected behavior is detected, the software can be hardened

to prevent unrecoverable errors occurring (see application note AN1015).

DocID024849 Rev 1

55/88

73

Share Link: