ST62P18CB1 Datasheet - STMicroelectronics

INTRODUCTION
The ST62P18C are the Factory Advanced Service Technique ROM (FASTROM) versions of ST62T18C OTP devices.
They offer the same functionality as OTP devices, selecting as FASTROM options the options defined in the programmable option byte of the OTP version.

■ 3.0 to 6.0V Supply Operating Range
■ 8 MHz Maximum Clock Frequency
■ -40 to +125°C Operating Temperature Range
■ Run, Wait and Stop Modes
■ 5 Interrupt Vectors
■ Look-up Table capability in Program Memory
■ Data Storage in Program Memory: User selectable size
■ Data RAM: 192 bytes
■ User Programmable Options
■ 12 I/O pins, fully programmable as:
    – Input with pull-up resistor
    – Input without pull-up resistor
    – Input with interrupt generation
    – Open-drain or push-pull output
    – Analog Input
■ 5 I/O lines can sink up to 20mA to drive LEDs or TRIACs directly
■ 8-bit Timer/Counter with 7-bit programmable prescaler
■ 8-bit Auto-reload Timer with 7-bit programmable prescaler (AR Timer)
■ Digital Watchdog
■ 8-bit A/D Converter with 7 analog inputs
■ 8-bit Asynchronous Peripheral Interface (UART)
■ On-chip Clockoscillator can be driven by Quartz Crystal or Ceramic resonator
■ Oscillator Safe Guard
■ Low Voltage Detector for safe Reset
■ One external Non-Maskable Interrupt
■ ST623x-EMU2 Emulation and Development System (connects to an MS-DOS PC via a parallel port).