PIC16LC717SS Datasheet - Microchip Technology

DEVICE OVERVIEW
This document contains device-specific information. Additional information may be found in the PICmicro™ Mid-Range Reference Manual, (DS33023), which may be obtained from your local Microchip Sales Representative or downloaded from the Microchip website. The Reference Manual should be considered a complementary document to this data sheet, and is highly recommended reading for a better understanding of the device architecture and operation of the peripheral modules.

Microcontroller Core Features:
• High-performance RISC CPU
• Only 35 single word instructions to learn
• All single cycle instructions except for program branches which are two cycle
• Operating speed: DC - 20 MHz clock input
                          DC - 200 ns instruction cycle
• Interrupt capability (up to 10 internal/external interrupt sources)
• Eight level deep hardware stack
• Direct, indirect and relative addressing modes
• Power-on Reset (POR)
• Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
• Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation
• Selectable oscillator options:
   - INTRC - Internal RC, dual speed (4MHz and 37KHz) dynamically switchable for power savings
   - ER - External resistor, dual speed (user selectable frequency and 37KHz) dynamically switchable for power savings
   - EC - External clock
   - HS - High speed crystal/resonator
   - XT - Crystal/resonator
   - LP - Low power crystal
• Low-power, high-speed CMOS EPROM technology
• In-Circuit Serial Programming™ (ISCP)
• Wide operating voltage range: 2.5V to 5.5V
• 15 I/O pins with individual control for:
   - Direction (15 pins)
   - Digital/Analog input (6 pins)
   - PORTB interrupt on change (8 pins)
   - PORTB weak pull-up (8 pins)
   - High voltage open drain (1 pin)
• Commercial and Industrial temperature ranges
• Low-power consumption:
   - < 2 mA @ 5V, 4 MHz
   - 22.5 µA typical @ 3V, 32 kHz
   - < 1 µA typical standby current

Peripheral Features:
• Timer0: 8-bit timer/counter with 8-bit prescaler
• Timer1: 16-bit timer/counter with prescaler, can be incremented during sleep via external crystal/clock
• Timer2: 8-bit timer/counter with 8-bit period register, prescaler and postscaler
• Enhanced Capture, Compare, PWM (ECCP) module
   - Capture is 16 bit, max. resolution is 12.5 ns
   - Compare is 16 bit, max. resolution is 200 ns
   - PWM max. resolution is 10 bit
   - Enhanced PWM:
   - Single, Half-Bridge and Full-Bridge output modes
   - Digitally programmable deadband delay
• Analog-to-Digital converter:
   - PIC16C770/771 12-bit resolution
   - PIC16C717 10-bit resolution
• On-chip absolute bandgap voltage reference generator
• Programmable Brown-out Reset (PBOR) circuitry
• Programmable Low-Voltage Detection (PLVD) circuitry
• Master Synchronous Serial Port (MSSP) with two modes of operation:
   - 3-wire SPI™ (supports all 4 SPI modes)
   - I2C™ compatible including master mode support
• Program Memory Read (PMR) capability for look up table, character string storage and checksum calculation purposes