MC9S08SC4 Datasheet - Freescale Semiconductor

8-Bit HCS08 Central Processor Unit (CPU)
• Up to 40 MHz HCS08 CPU (central processor unit); up to 20 MHz bus frequency
• HC08 instruction set with added BGND instruction

On-Chip Memory
• 4 KB of FLASH with read/program/erase over full operating voltage and temperature
• 256 bytes of Random-access memory (RAM)

Power-Saving Modes
• Two very low power stop modes
• Reduced power wait mode

Clock Source Options
• Oscillator (XOSC) — Loop-control Pierce oscillator; Crystal or ceramic resonator range of 32 kHz to 38.4 kHz or 1 MHz to 16 MHz
• Internal Clock Source (ICS) — Internal clock source module containing a frequency-locked loop (FLL) controlled by internal or external reference; precision trimming of internal reference allows 0.2 % resolution and 2.0 % deviation over temperature and voltage; supports bus frequencies from 2 MHz to 20 MHz.

System Protection
• Watchdog computer operating properly (COP) reset with option to run from dedicated 1 kHz internal clock source or bus clock
• Low-voltage detection with reset or interrupt; selectable trip points
• Illegal opcode detection with reset
• Illegal address detection with reset
• FLASH block protect
• Reset on loss of clock

Development Support
• Single-wire background debug interface
• Breakpoint capability to allow single breakpoint setting during in-circuit debugging

Peripherals
• SCI — Serial Communication Interface
   — Full-duplex non-return to zero (NRZ)
   — LIN master extended break generation
   — LIN slave extended break detection
   — Wake-up on active edge
• TPMx — Two 2-channel Timer/PWM modules (TPM1 and TPM2)
   — 16-bit modulus or up/down counters
   — Input capture, output compare, buffered edge-aligned or center-aligned PWM
• ADC — Analog to Digital Converter
   — 8-channel, 10-bit resolution
   — 2.5 μs conversion time
   — Automatic compare function
   — Temperature sensor
   — Internal bandgap reference channel

Input/Output
• 12 general purpose I/O pins (GPIOs)
• 8 interrupt pins with selectable polarity
• Hysteresis and configurable pull-up device on all input pins; Configurable slew rate and drive strength on all output pins.

Package Options
• 16-TSSOP

Operating Parameters
• 4.5-5.5 V operation
• C,V, M temperature ranges available, covering -40 - 125 °C operation