PSD934F210MIT View Datasheet(PDF) - STMicroelectronics

Part Name

Description

MFG CO.

PSD934F210MIT

Flash PSD, 3.3V Supply, for 8-bit MCUs 2 Mbit + 256 Kbit Dual Flash Memories and 64 Kbit SRAM

STMicroelectronics 

PSD834F2V

Specific Features

Flash Memory Sector Protect. Each primary

and secondary Flash memory sector can be sepa-

rately protected against Program and Erase cy-

cles. Sector Protection provides additional data

security because it disables all Program or Erase

cycles. This mode can be activated through the

JTAG Port or a Device Programmer.

Sector protection can be selected for each sector

using the PSDsoft Express Configuration pro-

gram. This automatically protects selected sectors

when the device is programmed through the JTAG

Port or a Device Programmer. Flash memory sec-

tors can be unprotected to allow updating of their

contents using the JTAG Port or a Device Pro-

grammer. The MCU can read (but cannot change)

the sector protection bits.

Any attempt to program or erase a protected Flash

memory sector is ignored by the device. The Verify

operation results in a read of the protected data.

This allows a guarantee of the retention of the Pro-

tection status.

The sector protection status can be read by the

MCU through the Flash memory protection and

PSD/EE protection registers (in the CSIOP block).

See Table 9 and Table 10.

Table 9. Sector Protection/Security Bit Definition – Flash Protection Register

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Sec7_Prot Sec6_Prot Sec5_Prot Sec4_Prot Sec3_Prot Sec2_Prot Sec1_Prot

Note: 1. Bit Definitions:

Sec<i>_Prot 1 = Primary Flash memory or secondary Flash memory Sector <i> is write protected.

Sec<i>_Prot 0 = Primary Flash memory or secondary Flash memory Sector <i> is not write protected.

Bit 0

Sec0_Prot

Table 10. Sector Protection/Security Bit Definition – PSD/EE Protection Register

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Security_Bit not used

not used

not used

Sec3_Prot Sec2_Prot Sec1_Prot

Note: 1. Bit Definitions:

Sec<i>_Prot 1 = Secondary Flash memory Sector <i> is write protected.

Sec<i>_Prot 0 = Secondary Flash memory Sector <i> is not write protected.

Security_Bit 0 = Security Bit in device has not been set.

1 = Security Bit in device has been set.

Bit 0

Sec0_Prot

22/89

Share Link: