C8051F362-GM View Datasheet(PDF) - Silicon Laboratories

Part Name

Description

MFG CO.

C8051F362-GM

Mixed Signal ISP Flash MCU Family

Silicon Laboratories 

C8051F360/1/2/3/4/5/6/7/8/9

8. Comparators

C8051F36x devices include two on-chip programmable voltage comparators, Comparator0 and

Comparator1, shown in Figure 8.1 and Figure 8.2 (Note: the port pin Comparator inputs differ between

C8051F36x devices. The first Port I/O pin shown is for C8051F360/3 devices).

The comparators offer programmable response time and hysteresis, an analog input multiplexer, and two

outputs that are optionally available at the Port pins: a synchronous “latched” output (CP0 and CP1), or an

asynchronous “raw” output (CP0A and CP1A). The asynchronous CP0A and CP1A signals are available

even when the system clock is not active. This allows the Comparators to operate and generate an output

with the device in STOP mode. When assigned to a Port pin, the Comparator outputs may be configured

as open drain or push-pull (see Section “17.2. Port I/O Initialization” on page 187). Comparator0 may also

be used as a reset source (see Section “12.5. Comparator0 Reset” on page 131).

The Comparator inputs are selected in the CPT0MX and CPT1MX registers (SFR Definition 8.2 and SFR

Definition 8.5). The CMXnP1–CMXnP0 bits select the Comparator positive input; the CMXnN1–CMXnN0

bits select the Comparator negative input.

Important Note About Comparator Inputs: The Port pins selected as comparator inputs should be con-

figured as analog inputs in their associated Port configuration register, and configured to be skipped by the

Crossbar (for details on Port configuration, see Section “17.3. General Purpose Port I/O” on page 190).

CMX0N3

CMX0N2

CMX0N1

CMX0N0

CMX0P1

CMX0P0

CP0EN

CP0OUT

CP0RIF

CP0FIF

CP0HYP1

CP0HYP0

CP0HYN1

CP0HYN0

VDD

P1.4 / P1.0

P2.3 / P1.4

P3.1 / P2.0

P3.5 / P2.4

P1.5 / P1.1

P2.4 / P1.5

P3.2 / P2.1

P3.6 / P2.5

CP0 +

+

-

GND

D SET Q

Q CLR

D SET Q

Q CLR

(SYNCHRONIZER)

Reset

Decision

Tree

CP0

Crossbar

CP0A

CP0 -

CP0RIE

CP0FIE

0

CP0RIF

1

0

CP0FIF

1

CP0EN

EA

0

1

CP0

0 Interrupt

1

CP0MD1

CP0MD0

Figure 8.1. Comparator0 Functional Block Diagram

70

Rev. 1.0

Share Link: