datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

SST55LD019C-45-C-MVWE View Datasheet(PDF) - Silicon Storage Technology

Part Name
Description
MFG CO.
SST55LD019C-45-C-MVWE
SST
Silicon Storage Technology 
SST55LD019C-45-C-MVWE Datasheet PDF : 79 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
ATA Flash Disk Controller
SST55LD019A / SST55LD019B / SST55LD019C
Data Sheet
8.0 CONFIGURABLE WRITE PROTECT/POWER-DOWN MODES
The WP_PD# pin can be used for either Write Protect mode or Power-down mode, but only one mode is active at any time.
Either mode can be selected through the host command, Set-WP_PD#-Mode, explained in Section 11.2.1.31.
Once the mode is set with this command, the device will stay in the configured mode until the next time this command is
issued. Power-off or reset will not change the configured mode.
8.1 Write Protect Mode
When the device is configured in the Write Protect mode, the WP_PD# pin offers extended data protection. This feature can
be either selected through a jumper or host logic to protect the stored data from inadvertent system writes or erases, and
viruses. The Write Protect feature protects the full address space of the data stored on the flash media.
In the Write Protect mode, the WP_PD# pin should be asserted prior to issuing the destructive commands: Erase-Sector,
Format-Track, Write-DMA, Write-Long-Sector, Write-Multiple, Write-Multiple-without-Erase, Write-Sector(s), Write-Sector-
without-Erase, or Write-Verify. This will force the ATA Flash Disk Controller to reject any destructive commands from the ATA
interface. All destructive commands will return 51H in the Status register and 04H in the Error register signifying an invalid
command. All non-destructive commands will be executed normally.
8.2 Power-down Mode
When the device is configured in the Power-down mode, if the WP_PD# pin is asserted during a command, the ATA disk
controller completes the current command and returns to the standby mode immediately to save power. Afterwards, the
device will not accept any other commands. Only a Power-on Reset (POR) or hardware reset will bring the device to normal
operation with the WP_PD# pin de-asserted.
©2006 Silicon Storage Technology, Inc.
17
S71241-04-000
12/06

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]