STFPC311(2012) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

MFG CO.

STFPC311
(Rev.:2012)

Front panel controller/driver with standby power management

STMicroelectronics 

STFPC311

Commands

For RC-5 data reception (after the photodiode), a binary 1 is represented by a high-to-low

transition, and a binary 0 is represented by a low-to-high transition. For RC-6 (Mode 0) data

reception, a binary 1 is represented by a low-to-high transition, and a binary 0 is

represented by a high-to-low transition. Whenever bit 5 is a ‘1’, the watchdog timer is reset.

6.3

Address setting command

This command sets an address of the display memory. If address 30H or higher is set, the

data is ignored until a correct address is set.

Figure 17. STFPC311 address setting command order

te Product(s) 6.4

Display control and hotkey setting command

ole When the application is powered-up, the 1/16-pulse width is set and the display is turned

s OFF.

b See Figure 18 and Figure 4. All hot keys are disabled.

Obsolete Product(s) - O Figure 18. STFPC311 display control and hot key setting command order

Doc ID 12324 Rev 2

21/39

Share Link: