CS5376A(2004) 查看數據表（PDF） - Cirrus Logic

零件编号

产品描述 (功能)

生产厂家

CS5376A
(Rev.:2004)

Low Power Multi-Channel Decimation Filter

Cirrus Logic 

CS5376A

Digital

Filter

SCK2

SCKFS[2:0] / SCKPO / SCKPH

SO

Pin logic

SI1

SI2

4:1 SI3

SPI2EN[4:1] / RCH[1:0]

SI4

CS[4:0]

CS0

CS1

Select

CS2

logic

CS3

CS4

Figure 39. Serial Peripheral Interface 2 (SPI 2) Block Diagram

20. SERIAL PERIPHERAL INTERFACE 2

The Serial Peripheral Interface 2 (SPI 2) port is a

master mode SPI port designed to interface with se-

rial peripherals. By writing the SPI2 digital filter

registers, multiple serial slave devices can be con-

trolled through the CS5376A.

20.1 Pin Descriptions

CS[4:0] - Pins 32 - 36

Serial chip selects. Multiplexed with GPIO pins.

SCK2 - Pin 31

Serial clock output, common to all channels.

SO - Pin 30

Serial data output, common to all channels.

SI[4:1] - Pins 26 - 29

Serial data inputs.

20.2 SPI 2 Architecture

The SPI 2 pin interface has multiple chip selects

and serial data inputs, but a common serial clock

and serial data output. Which chip select and serial

input to use for a particular slave serial transaction

is selected by bits in the SPI2CTRL digital filter

register.

SPI 2 chip select outputs are multiplexed with

GPIO pins, which cannot perform both functions

simultaneously. When used as a chip select, the

GPIO output must be programmed high to permit

the chip select to operate as an active low signal.

See “General Purpose I/O” on page 69 for informa-

tion about programming the GPIO pins.

The SPI 2 interface transfers data from the SPI 2

registers to a slave serial device and back through a

bi-directional 8-bit shift register. Serial transac-

tions are automatic once control, command, and

data values are written into the SPI 2 digital filter

registers.

20.3 SPI 2 Registers

SPI 2 transactions are initiated by first writing

command, address, and data values to the

SPI2CMD and SPI2DAT digital filter registers,

and then writing the SPI2CTRL register to set the

D2SREQ bit. The D2SREQ bit initiates a serial

71

Share Link: