CS5376A(2004) 查看數據表（PDF） - Cirrus Logic

零件编号

产品描述 (功能)

生产厂家

CS5376A
(Rev.:2004)

Low Power Multi-Channel Decimation Filter

Cirrus Logic 

CS5376A

Digital Filter

Command

Interpreter

SPI 1

Registers

SPI 1

Pin Logic

SSI

SCK1

MOSI

SINT

MISO

Figure 17. Serial Peripheral Interface 1 (SPI 1) Block Diagram

9. CONFIGURATION BY MICROCONTROLLER

After reset, the CS5376A reads the state of the

BOOT pin to determine a source for configuration

commands. If BOOT is low, the CS5376A receives

configuration commands from a microcontroller.

9.1 Pin Descriptions

Pins required for microcontroller boot are listed

here, other SPI 1 pins are inactive.

SSI - Pin 49

Slave select input pin, active low. Serial chip select

input from a microcontroller.

9.2 Microcontroller Hardware Interface

When booting from a microcontroller the

CS5376A SPI 1 port receives configuration com-

mands and configuration data through serial trans-

actions, as shown in Figure 18. 8-bit SPI opcodes

and 8-bit addresses are combined to read and write

24-bit configuration commands and data.

Microcontroller serial transactions require toggling

the SSI pin as the CS5376A chip select and writing

a serial clock to the SCK1 input. Serial data is input

to the CS5376A on the MOSI pin, and output from

the CS5376A on the MISO pin.

SCK1 - Pin 48

Serial clock input pin. Serial clock input from mi-

crocontroller, maximum 4.096 MHz.

MOSI - Pin 51

Serial data input pin. Valid on rising edge of SCK1,

transition on falling edge.

MISO - Pin 50

9.3 Microcontroller Serial Transactions

Microcontroller configuration commands are writ-

ten to the digital filter through the SPI 1 registers.

A 24-bit command and two 24-bit data words can

be written to the SPI 1 registers in any single serial

transaction. Some commands require additional

data words through additional serial transactions to

complete.

Serial data output pin. Valid on rising edge of

SCK1, transition on falling edge. Open drain out-

put requiring a 10 kΩ pull-up resistor.

SINT - Pin 52

Serial interrupt output pin, active low. 1 uS active

low pulse output when ready for next serial trans-

action.

9.3.1 SPI opcodes

A microcontroller communicates with the

CS5376A SPI 1 port using standard 8-bit SPI op-

codes and an 8-bit SPI address. The standard SPI

‘Read’ and ‘Write’ opcodes are listed in Figure 18.

32

Share Link: