CS5467-ISZ 查看數據表（PDF） - Cirrus Logic

零件编号

产品描述 (功能)

生产厂家

CS5467-ISZ

Four-channel Power / Energy IC

Cirrus Logic 

CS5467

7.6 Commands

All commands are 1 byte (8 bits) long. Many command values are unused and should NOT be written by the

application program. All commands except register reads, register writes, or synchronizing commands will

abort any conversion, calibration, or any initialization sequence currently executing. This includes reset. No

commands other than reads or synchronizing should be executed until the reset sequence completes.

7.6.1 Conversion

B7 B6 B5 B4 B3 B2 B1 B0

1

1

1

0 CC 0

0

0

Executes a conversion (measurement) program.

CC

Continuous/Single Conversion

0 = Perform a Single Conversion (0xE0)

1 = Perform Continuous Conversion (0xE8)

7.6.2 Synchronization (SYNC0 and SYNC1)

B7 B6 B5 B4 B3 B2 B1 B0

1

1

1

1

1

1

1 SYNC

The serial interface is bidirectional. While reading data on the SDO output, the SDI input must be receiving

commands. If no command is needed during a read, SYNC0 or SYNC1 commands can be sent while read

data is received on SDO.

The serial port is normally initialized by de-asserting CS. An alternative method of initialization is to send 3 or

more SYNC1 commands followed by a SYNC0. This is useful in systems where CS is not used and tied low.

7.6.3 Power Control (Stand-by, Sleep, Wake-up/Halt and Software Reset)

B7 B6 B5 B4 B3 B2 B1 B0

1

0

S1 S0

0

0

0

0

The CS5467 has two power-down states, stand-by and sleep. In stand-by, all circuitry except the voltage ref-

erence and clocks are turned off. In sleep mode, all circuitry except the command decoder is turned off. A

Wake-up/Halt command restores full-power operation after stand-by and issues a hardware reset after sleep.

The Software Reset command is a program that emulates a pin reset and is not a power control function.

S[1:0]

00 = Software Reset

01 = Sleep

10 = Wake-up/Halt

11 = Stand-by

DS714F1

25

Share Link: