CS44L11 查看數據表（PDF） - Cirrus Logic
零件编号
产品描述 (功能)
生产厂家
CS44L11 Datasheet PDF : 34 Pages
| |||
4.5.3
CS44L11
Tone Control Mode (TC)
Default = 00
00 - All settings are taken from user registers
01 - 12 dB of Bass Boost at 100 Hz and 6 dB of Treble Boost at 7 kHz (at LRCK = 48 kHz)
10 - 8 dB of Bass Boost at 100 Hz and 4 dB of Treble Boost at 7 kHz (at LRCK = 48 kHz)
11 - 4 dB of Bass Boost at 100 Hz and 2 dB of Treble Boost at 7 kHz (at LRCK = 48 kHz)
Function:
The Tone Control Mode bits determine how the Bass Boost and Treble Boost features are configured.
The user-defined settings from the Bass and Treble Boost Level and Corner Frequency registers are used
when these bits are set to ‘00’. Alternately, one of three pre-defined settings may be used (these settings
are a function of LRCK - refer to Tables 5, 6, and 7).
Note: Treble Boost is not available in Double-Speed Mode.
4.5.4
Tone Control Enable (TC_EN)
Default = 0
0 - Disabled
1 - Enabled
Function:
The Bass Boost and Treble Boost features are active when this function is enabled.
4.5.5
Peak Signal Limiter Enable (LIM_EN)
Default = 0
0 - Disabled
1 - Enabled
Function:
The CS44L11 will limit the maximum signal amplitude to prevent clipping when this function is enabled.
Peak Signal Limiting is performed by first decreasing the Bass and Treble Boost Levels. If the signal is
still clipping, the digital attenuation is increased. The attack rate is determined by the Limiter Attack Rate
register.
Once the signal has dropped below the clipping level, the attenuation is decreased back to the user-se-
lected level, followed by the Bass Boost being increased back to the user-selected level. The release rate
is determined by the Limiter Release Rate register.
Note: The A=B bit should be set to ‘1’ for optimal limiter performance.
DS640PP4
17
Share Link: 