C8051F362-GM2 查看數據表（PDF） - Silicon Laboratories

零件编号

产品描述 (功能)

生产厂家

C8051F362-GM2

Mixed Signal ISP Flash MCU Family

Silicon Laboratories 

C8051F360/1/2/3/4/5/6/7/8/9

5.2. Temperature Sensor

The typical temperature sensor transfer function is shown in Figure 5.2. The output voltage (VTEMP) is the

positive ADC input when the temperature sensor is selected by bits AMX0P4-0 in register AMX0P.

(mV)

1200

1100

1000

900

VTEMP = Slope*(TEMPC) + Offset mV

800

700

-50

0

50

100

(Celsius)

Figure 5.2. Typical Temperature Sensor Transfer Function

The uncalibrated temperature sensor output is extremely linear and suitable for relative temperature mea-

surements (see Table 5.1 for linearity specifications). For absolute temperature measurements, gain and/

or offset calibration is recommended. Typically a 1-point calibration includes the following steps:

Step 1. Control/measure the ambient temperature (this temperature must be known).

Step 2. Power the device, and delay for a few seconds to allow for self-heating.

Step 3. Perform an ADC conversion with the temperature sensor selected as the positive input

and GND selected as the negative input.

Step 4. Calculate the offset and/or gain characteristics, and store these values in non-volatile

memory for use with subsequent temperature sensor measurements.

Figure 5.3 shows the typical temperature sensor error assuming a 1-point calibration at 25 °C. Note that

parameters which affect ADC measurement, in particular the voltage reference value, will also

affect temperature measurement.

Rev. 1.0

49

Share Link: