CS5516-ASZ 查看數據表（PDF） - Cirrus Logic
零件编号
产品描述 (功能)
生产厂家
CS5516-ASZ Datasheet PDF : 41 Pages
| |||
CDB5516/CDB5520
must be removed from between the +VREF and
-VREF pins. It may be desirable to also remove
R5, R7, C16, and C17 in some applications.
Calibrating the A/D Converter
As explained in the CS5516/CS5520 data sheet,
the order in which the calibration steps are per-
formed are important. If one chooses to use the
non-ratiometric calibration capabilities of the
converter, the non-ratiometric errors of the
VREF and AIN channels should be calibrated
first. The non-ratiometric calibration steps can
be performed at the same time. Before the non-
ratiometric offset calibration is initiated, the
bridge should be grounded. This can be achieved
on the evaluation board by moving the two
jumpers at the output of the MIC4428 driver to
the GND position (see Figure 1). The converter
is then instructed via the configuration register
bits to perform the non-ratiometric calibration
steps. Once the non-ratiometric calibrations are
completed, jumpers at the output of the
MIC4428 driver should be returned to the EXC
position.
After the non-ratiometric calibration steps are
performed, the AIN ratiometric offset is then
calibrated. With "zero weight" on the load cell,
the converter is instructed via the configuration
register to perform the AIN ratiometric offset
calibration step. Finally, with "full scale weight"
on the load cell, the converter is instructed to
perform the gain calibration step.
The converter is then ready to perform conver-
sions.
Software
The evaluation board comes with software and a
RS-232 cable to interface the board to a RS-232
port of a PC-compatible computer. The software
diskette contains a README.TXT file which
explains its operation.
+5V
Z1
AGND
Z2
-5V
3366
+
C3
47µF
+5VA
C4
0.1µF
+5
Z3
DGND
+
C1
47µF
C2
0.1µF
-5VA
+
C5
47µF
+5VD
C6
0.1µF
Figure 6. Using Off-board Voltage Reference
DS74DB43
Share Link: 