TSH511 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

TSH511

Hi-fi stereo/mono infrared receiver and stereo sub-carrier demodulator

STMicroelectronics 

TSH511

Figure 29. Squelch schematics

General description

The squelch section is driven by the receiver RX1 but controls both audio buffers.

8.5

Audio buffer sections

The audio signal from an FM demodulator enters into the 6dB/octave low-pass filter for de-

emphasis. 50µs and 75µs are standard de-emphasis values.

After the de-emphasis network, the potentiometer controls the volume.

The rail-to-rail output stage of each audio buffer is able to drive 20mW into 16Ω at 2.3V

supply voltage. Under these conditions, the distortion is typically 0.3% before saturation.

The audio buffers can also drive the other usual impedances used in audio: 32Ω, 600Ω and

10kΩ (see the corresponding distortion curves).

The high input impedances of the audio buffers reduce the coupling capacitors to less than

0.1µF allowing space and cost saving.

21/25

Share Link: