PCA8538UG(2014) 데이터 시트보기 (PDF) - NXP Semiconductors.

부품명

상세내역

제조사

PCA8538UG
(Rev.:2014)

Automotive 102 x 9 Chip-On-Glass LCD segment driver

NXP Semiconductors. 

NXP Semiconductors

PCA8538

Automotive 102 x 9 Chip-On-Glass LCD segment driver

9. Bus interfaces

9.1 Control byte and register selection

After initiating the communication over the bus and sending the slave address (I2C-bus,

see Section 9.2) or subaddress (SPI-bus, see Section 9.3 on page 68), a control byte

follows. The purpose of this byte is to indicate both, the content for the following data

bytes (RAM or command) and to indicate that more control bytes will follow.

Typical sequences could be:

• Slave address/subaddress - control byte - command byte - command byte - command

byte - end

• Slave address/subaddress - control byte - RAM byte - RAM byte - RAM byte - end

• Slave address/subaddress - control byte - command byte - control byte - RAM byte -

end

This allows sending a mixture of RAM and command data in one access or alternatively,

to send just one type of data in one access. In this way, it is possible to configure the

device and then fill the display RAM with little overhead. The display bytes are stored in

the display RAM at the address specified by the data pointer.

Table 46. Control byte description

Bit

Symbol

Value

7

CO

0

1

6 to 5 RS[1:0]

00, 10

01

11

4 to 0 -

-

Description

continue bit

last control byte

control bytes continue

register selection

command register

RAM data

unused

unused

06%



&2 56>@



QRWUHOHYDQW

/6%



Fig 37. Control byte format

DDD

PCA8538

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 4 — 26 September 2014

© NXP Semiconductors N.V. 2014. All rights reserved.

63 of 107

Share Link: