CS5467-ISZ 데이터 시트보기 (PDF) - Cirrus Logic

부품명

상세내역

제조사

CS5467-ISZ

Four-channel Power / Energy IC

Cirrus Logic 

CS5467

10. E2PROM OPERATION

The CS5467 can accept commands from a serial

E2PROM connected to the serial interface instead of a

host microcontroller. A high level (logic 1) on the MODE

input indicates that an E2PROM is connected. This

makes the CS and SCLK pins become driven outputs.

After reset and after running the initialization program,

the CS5467 begins reading commands from the con-

nected E2PROM.

10.1 E2PROM Configuration

A typical connection between the CS5467 and a

E2PROM is shown in Figure 13.

The CS5467 asserts CS (logic 0), clocks SCLK, and

sends Read commands to the E2PROM on SDO.

Command format is identical to microcontroller mode,

except the CS5467 will not attempt to write to the EE-

PROM device. The command sequence stops when the

STOP bit in the Control register (Ctrl) is written by the

command sequence.

VD

+

5K

E1

E2

CS5467

SCLK

SDI

SDO

MODE

CS

Pulse Output

Counter

5K

EEPROM

SCK

SO

SI

CS

Connector to Calibrator

Figure 13. Typical Interface of E2PROM to CS5467

Figure 13 also shows the external connections that

would be made to a calibration device, such as a note-

book computer, handheld calibrator, or tester during

meter assembly, The calibrator or tester can be used to

control the CS5467 during calibration and program the

required values into the E2PROM.

10.2 E2PROM Code

The EEPROM code should do the following:

1. Set any Configuration or Control register bits, such as

HPF enables and phase compensation settings.

2. Write any calibration data to gain and offset registers.

3. Set energy output pulse width, rate, and formats.

4. Execute a Continuous Conversion command.

5. Set the STOP bit in the Control register (last).

Below is an example E2PROM code set.

-7E 00 00 01

Change to page 1.

-60 00 01 E0

Write Modes Register, turn high-pass filters on.

-42 7F C4 A9

Write value of 0x7FC4A9 to I1GAIN register.

-46 FF B2 53

Write value of 0xFFB253 to V1GAIN register.

-50 7F C4 A9

Write value of 0x7FC4A9 to I2GAIN register.

-54 FF B2 53

Write value of 0xFFB253 to V2GAIN register.

-7E 00 00 00

Change to page 0.

-74 00 00 04

Set LSD bit to 1 in the Mask register.

-E8

Start continuous conversions

-78 00 01 00

Write STOP bit to the Control register (Ctrl) to

terminate E2PROM command sequence.

10.3 Which E2PROMs Can Be Used?

Several industry-standard serial E2PROMs can be used

with the CS5467. Some are listed below:

• Atmel AT25010, AT25020 or AT25040

• National Semiconductor NM25C040M8 or NM25020M8

• Xicor X25040SI

These serial E2PROMs expect a specific 8-bit com-

mand (00000011) in order to perform a memory read.

The CS5467 has been hardware programmed to trans-

mit this 8-bit command to the E2PROM after reset.

42

DS714F1

Share Link: