CS44L10 データシートの表示（PDF） - Cirrus Logic

部品番号

コンポーネント説明

メーカー

CS44L10

Digital PWM Headphone Monitor

Cirrus Logic 

CS44L10

LRCK

SCLK

SDATA

Left Channel

Right Channel

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

32 clocks

Figure 19. Right Justified, 16-Bit Data

8. PARAMETER DEFINITIONS

Total Harmonic Distortion + Noise (THD+N)

The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified

bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.

Dynamic Range

The ratio of the full scale rms value of the signal to the rms sum of all other spectral components over the

specified bandwidth. Dynamic range is a signal-to-noise measurement over the specified bandwidth

made with a -60 dBFS signal. 60 dB is then added to the resulting measurement to refer the measurement

to full scale. This technique ensures that the distortion components are below the noise level and do not

effect the measurement. This measurement technique has been accepted by the Audio Engineering So-

ciety, AES17-1991, and the Electronic Industries Association of Japan, EIAJ CP-307.

Interchannel Isolation

A measure of crosstalk between the left and right channels. Measured for each channel at the converter’s

output with all zeros to the input under test and a full-scale signal applied to the other channel. Units in

decibels.

Interchannel Gain Mismatch

The gain difference between left and right channels. Units in decibels.

9.0 REFERENCES

1) “The I2C-Bus Specification: Version 2.0” Philips Semiconductors, December 1998.

http://www.semiconductors.philips.com

32

DS541PP1

Share Link: