CS5331A(1999) データシートの表示（PDF） - Cirrus Logic

部品番号

コンポーネント説明

メーカー

CS5331A
(Rev.:1999)

8-Pin, Stereo A/D Converter for Digital Audio

Cirrus Logic 

CDB5330A / CDB5331A

The transceiver operates as a transmitter with the

MASTER/SLAVE jumper in the MASTER posi-

tion. LRCK, SDATA, and SCLK from the

CS5330A/31A will be available on HDR2.

HDR22 must be in the 0 position and HDR23

must be in the 1 position for MCLK to be an

output and to avoid bus contention on MCLK.

The transceiver operates as a receiver with the

MASTER/SLAVE jumper in the SLAVE posi-

tion. LRCK and SCLK on HDR2 become inputs.

However, the recommended mode of operation is

to generate MCLK on the evaluation board with

HDR23 in the 0 position and HDR22 in the 1

position. These default settings allow MCLK to

be an output, with LRCK and SCLK as inputs.

MCLK is always an output from the evaluation

board.

Grounding and Power Supply Decoupling

The CS5330A/31A requires careful attention to

power supply and grounding arrangements to op-

timize performance. Figure 2 shows the

recommended power arrangements. The

CS5330A/31A is positioned over the analog

ground plane, near the digital/analog ground

plane split, to minimize the distance that the

clocks travel. The series resistors are present on

the clock lines to reduce the effects of transient

currents when driving a capacitive load in master

mode, and reduce clock overshoot when apply-

ing external clocks to the CS5330A/31A in slave

mode.

This layout technique is used to minimize digital

noise and to insure proper power supply match-

ing/sequencing. The decoupling capacitors are

located as close to the CS5330A/31A as possi-

ble. Extensive use of ground plane fill on both

the analog and digital sections of the evaluation

board yield large reductions in radiated noise ef-

fects.

CONNECTOR

+5V

GND

AINL

AINR

MCLK, SCLK, LRCK,

SDATA

Digital Output

Optical Output

INPUT/OUTPUT

input

input

input

input

input/output

output

output

SIGNAL PRESENT

(VD+) for CS8402A and digital section

(VA+) for CS5330A/31A and Analog input filter op-amp

ground connection from power supply

left channel analog input

right channel analog input

I/O for master, serial, left/right clocks, and serial DATA

digital audio interface output via coax

digital audio interface output via optical

Table 1. System Connections

DS138DB2

19

Share Link: