CS42L52(2006) View Datasheet(PDF) - Cirrus Logic

Part Name

Description

MFG CO.

CS42L52
(Rev.:2006)

Low Power, Stereo CODEC w/Headphone & Speaker Amps

Cirrus Logic 

6.22.2 Beep Volume

Sets the volume of the beep signal.

BEEPVOL[4:0]

00110

···

00000

11111

11110

···

00111

Step Size:

Application:

Gain

+12.0 dB

···

0 dB

-2 dB

-4 dB

···

-50 dB

2 dB

“Beep Generator” on page 30

Note: This setting must not change when BEEP is enabled.

CS42L52

6.23 Beep & Tone Configuration (Address 1Eh)

7

BEEP1

6

BEEP0

5

4

BEEPMIXDIS TREBCF1

3

TREBCF0

2

BASSCF1

1

BASSCF0

0

TCEN

6.23.1 Beep Configuration

Configures a beep mixed with the HP/Line and SPK output.

BEEP[1:0]

00

01

10

11

Application:

Beep Occurrence

Off

Single

Multiple

Continuous

“Beep Generator” on page 30

Notes:

1. When used in analog pass through mode, the output alternates between the signal from the PGA and

the beep signal. The beep signal does not mix with the analog signal from the PGA.

2. Re-engaging the beep before it has completed its initial cycle will cause the beep signal to remain ON

for the maximum ONTIME duration.

6.23.2 Beep Mix Disable

Configures how the beep mixes with the serial data input.

BEEPMIXDIS

0

1

Application:

Beep Output to HP/Line and Speaker

Mix Enabled; The beep signal mixes with the digital signal from the serial data input.

Mix Disabled; The output alternates between the signal from the serial data input and the beep signal. The

beep signal does not mix with the digital signal from the serial data input.

“Beep Generator” on page 30

Note: This setting must not change when BEEP is enabled.

DS680A1

61

Share Link: