ST7PLITE35F2B6TR View Datasheet(PDF) - STMicroelectronics

Part Name

Description

MFG CO.

ST7PLITE35F2B6TR

8-bit MCU with single voltage Flash, data EEPROM, ADC, timers, SPI, LINSCI™

STMicroelectronics 

ST7LITE3xF2

I/O PORTS (Cont’d)

Analog alternate function

Configure the I/O as floating input to use an ADC

input. The analog multiplexer (controlled by the

ADC registers) switches the analog voltage

present on the selected pin to the common analog

rail, connected to the ADC input.

Analog Recommendations

Do not change the voltage level or loading on any

I/O while conversion is in progress. Do not have

clocking pins located close to a selected analog

pin.

WARNING: The analog input voltage level must

be within the limits stated in the absolute maxi-

mum ratings.

10.3 I/O PORT IMPLEMENTATION

The hardware implementation on each I/O port de-

pends on the settings in the DDR and OR registers

and specific I/O port features such as ADC input or

open drain.

Switching these I/O ports from one state to anoth-

er should be done in a sequence that prevents un-

wanted side effects. Recommended safe transi-

tions are illustrated in Figure 32. Other transitions

are potentially risky and should be avoided, since

they may present unwanted side-effects such as

spurious interrupt generation.

Figure 32. Interrupt I/O Port State Transitions

01

00

10

11

INPUT INPUT OUTPUT OUTPUT

floating/pull-up floating open-drain push-pull

interrupt (reset state)

XX = DDR, OR

10.4 UNUSED I/O PINS

Unused I/O pins must be connected to fixed volt-

age levels. Refer to Section 13.8.

10.5 LOW POWER MODES

Mode

WAIT

HALT

Description

No effect on I/O ports. External interrupts

cause the device to exit from WAIT mode.

No effect on I/O ports. External interrupts

cause the device to exit from HALT mode.

10.6 INTERRUPTS

The external interrupt event generates an interrupt

if the corresponding configuration is selected with

DDR and OR registers and if the I bit in the CC

register is cleared (RIM instruction).

Interrupt Event

Event

Flag

Enable

Control

Bit

Exit

from

Wait

External interrupt on

selected external

-

event

DDRx

ORx

Yes

Exit

from

Halt

Yes

Related Documentation

AN 970: SPI Communication between ST7 and

EEPROM

AN1045: S/W implementation of I2C bus master

AN1048: Software LCD driver

50/173

1

Share Link: