CS61884-IB View Datasheet(PDF) - Cirrus Logic

Part Name

Description

MFG CO.

CS61884-IB

Octal T1/E1/J1 Line Interface Unit

Cirrus Logic 

CS61884

16. JTAG SUPPORT

The CS61884 supports the IEEE Boundary Scan

Specification as described in the IEEE 1149.1 stan-

dards. A Test Access Port (TAP) is provided that

consists of the TAP controller, the instruction reg-

ister (IR), by-pass register (BPR), device ID regis-

ter (IDR), the boundary scan register (BSR), and

the 5 standard pins (TRST, TCK, TMS, TDI, and

TDO). A block diagram of the test access port is

shown in Figure 15. The test clock input (TCK) is

used to sample input data on TDI, and shift output

data through TDO. The TMS input is used to step

the TAP controller through its various states.

The instruction register is used to select test execu-

tion or register access. The by-pass register pro-

vides a direct connection between the TDI input

and the TDO output. The device identification reg-

ister contains an 32-bit device identifier.

The Boundary Scan Register is used to support test-

ing of IC inter-connectivity. Using the Boundary

Scan Register, the digital input pins can be sampled

and shifted out on TDO. In addition, this register

can also be used to drive digital output pins to a

user defined state.

16.1 TAP Controller

The TAP Controller is a 16 state synchronous state

machine clocked by the rising edge of TCK. The

TMS input governs state transitions as shown in

Figure 16. The value shown next to each state tran-

sition in the diagram is the value that must be on

TMS when it is sampled by the rising edge of TCK.

16.1.1 JTAG Reset

TRST resets all JTAG circuitry.

16.1.2 Test-Logic-Reset

The test-logic-reset state is used to disable the test

logic when the part is in normal mode of operation.

This state is entered by asynchronously asserting

TRST or forcing TMS High for 5 TCK periods.

16.1.3 Run-Test-Idle

The run-test-idle state is used to run tests.

Digital output pins

Digital input pins

parallel latched

output

JTAG BLOCK

TDI

TCK

TMS

Boundary Scan Data Register

Device ID Data Register

Bypass Data Register

Instruction (shift) Register

parallel latched output

TAP

Controller

MUX

TDO

Figure 15. Test Access Port Architecture

DS485F1

45

Share Link: