CS61318-IP View Datasheet(PDF) - Cirrus Logic

Part Name

Description

MFG CO.

CS61318-IP

E1 Line Interface Unit

Cirrus Logic 

CS61318

SDI - Serial Data Input, Pin 24 (Host Mode).

Data input to the on-chip register is sampled on the rising edge of SCLK. Note: this pin should be tied

to GND during Hardware Mode.

SDO - Serial Data Output, Pin 25 (Host Mode).

Status and control information are output from the on-chip register on SDO. If CLKE is high, SDO is

valid on the rising edge of SCLK. If CLKE is low, SDO is valid on the falling edge of SCLK. SDO goes

to a high-impedance state when the serial port is being written to, or after bit D7 is output or CS goes

high (whichever occurs first). Note: this pin should be tied to GND during Hardware Mode.

CS - Chip Select, Pin 26 (Host Mode).

The serial interface is accessible when CS transitions from high to low.

SCLK - Serial Clock Input, Pin 27 (Host Mode).

SCLK is used to write or read data bits to or from the serial port registers.

CLKE - Clock Edge, Pin 28 (Host Mode).

Setting CLKE to logic 1 causes RPOS and RNEG (RDATA) to be valid on the falling edge of RCLK, and

SDO to be valid on the rising edge of SCLK. Conversely, setting CLKE to logic 0 causes RPOS and

RNEG (RDATA) to be valid on the rising edge of RCLK and SDO to be valid on the falling edge of

SCLK.

4.6 Data Input/Output

TCLK - Transmit Clock Input, Pin 2.

The 2.048 MHz transmit clock is input on this pin. TPOS and TNEG or TDATA are sampled on the

falling edge of TCLK.

TPOS/TNEG - Transmit Positive Pulse, Transmit Negative Pulse, Pins 3 and 4.

Data input to TPOS and TNEG is sampled on the falling edge of TCLK and transmitted onto the line at

TTIP and TRING. An input on TPOS results in transmission of a positive pulse; an input on TNEG

results in transmission of a negative pulse. If TNEG, pin 4, is held high for 16 TCLK cycles, the

CS61318 reconfigures for unipolar (single pin NRZ) data input at pin 3, TDATA. If pin 4 goes low the

CS61318 switches back to two-pin bipolar data input format.

TDATA - Transmit Data, Pin 3.

When pin 4, TNEG/UBS, is held high, pin 3 becomes TDATA, a single-line NRZ (unipolar) data input

sampled on the falling edge of TCLK.

UBS - Unipolar / Bipolar Select, Pin 4.

When UBS is held high for 16 consecutive TCLK cycles (15 consecutive bipolar violations) the CS61318

reconfigures for unipolar (single-line NRZ) data input / output format. Pin 3 becomes TDATA, pin 7

becomes RDATA, and pin 6 becomes BPV.

RCLK - Recovered Clock Output, Pin 8.

RCLK outputs the clock recovered from the input signal at RTIP and RRING. In a Loss of Signal state

RCLK reverts to the MCLK frequency, or retains the frequency prior to the LOS state, depending on the

clocks provided. See the LOS pin description.

22

DS441PP2

Share Link: