CS8416-DSZR View Datasheet(PDF) - Cirrus Logic

Part Name

Description

MFG CO.

CS8416-DSZR

192 kHz Digital Audio Interface Receiver

Cirrus Logic 

18.2.2 Capacitor Selection

CS8416

The type of capacitors used for the PLL filter can have a significant effect on receiver performance. Large

or exotic film capacitors are not necessary as their leads and the required longer circuit board traces add

undesirable inductance to the circuit. Surface mount ceramic capacitors are a good choice because their

own inductance is low, and they can be mounted close to the FILT pin to minimize trace inductance. For

CRIP, a C0G or NPO dielectric is recommended, and for CFLT, an X7R dielectric is preferred. Avoid ca-

pacitors with large temperature co-coefficient, or capacitors with high dielectric constants, that are sensi-

tive to shock and vibration. These include the Z5U and Y5V dielectrics.

18.2.3 Circuit Board Layout

Board layout and capacitor choice affect each other and determine the performance of the PLL. Figure 24

contains a suggested layout for the PLL filter components and for bypassing the analog supply voltage.

The 0.1 µF bypass capacitor is in a 1206 form factor. RFLT, CFLT, CRIP, and the 1000 pF decoupling ca-

pacitor are in an 0805 form factor. The traces are on the top surface of the board with the IC so that there

is no via inductance. The traces themselves are short to minimize the inductance in the filter path. The

VA and AGND traces extend back to their origin and are shown only in truncated form in the drawing.

1000

pF

CRIP

.1µF

CFLT

Figure 24. Recommended Layout Example

18.2.4 Component Value Selection

The external PLL component values are listed in Table 6.

Range (kHz)

32 - 192

RFLT

3 kΩ

CFLT

22 nF

CRIP

1 nF

Table 6. External PLL Component Values

Settling Time

4 ms

54

DS578F3

Share Link: