CS5378 View Datasheet(PDF) - Cirrus Logic
Part Name
Description
MFG CO.
CS5378 Datasheet PDF : 88 Pages
| |||
CS5378
VD
SS:EECS 27
CS5378
SCK 24
MISO 25
MOSI 26
1 CS
387
WP VCC HOLD
6 SCK
2
SO
AT25640
5 SI
4
GND
Figure 14. EEPROM Configuration Block Diagram
8. CONFIGURATION BY EEPROM
After reset, the CS5378 reads the state of the
GPIO7:BOOT pin to determine a source for con-
figuration commands. If BOOT is high, the
CS5378 initiates serial transactions to read config-
uration information from an external EEPROM.
8.1 Pin Descriptions
Pins required for EEPROM boot are listed here,
other serial pins are inactive.
SCK - Pin 24
Serial clock output, nominally 1.024 MHz.
MISO - Pin 25
Serial data input pin. Valid on rising edge of SCK,
transition on falling edge.
MOSI - Pin 26
Serial data output pin. Valid on rising edge of
SCK, transition on falling edge.
SS:EECS - Pin 27
EEPROM chip select output, active low.
8.2 EEPROM Hardware Interface
When booting from EEPROM the CS5378 actively
performs serial transactions, as shown in Figure 15,
to read configuration commands and data. 8-bit
SPI opcodes and 16-bit addresses are combined to
read back 8-bit configuration commands and 24-bit
configuration data.
System design should include a connection to the
configuration EEPROM for in-circuit reprogram-
ming. The CS5378 serial pins tri-state when inac-
tive to support external connections to the serial
bus.
8.3 EEPROM Organization
The boot EEPROM holds the 8-bit commands and
24-bit data required to initialize the CS5378 into an
operational state. Configuration information starts
at memory location 0x10, with addresses 0x00 to
0x0F free for use as manufacturing header informa-
tion.
The first serial transaction reads a 1-byte command
from memory location 0x10 and then, depending
on the command type, reads multiple 3-byte data
words to complete the command. Command and
data reads continue until the ‘Filter Start’ command
is recognized.
DS639F2
25
Share Link: 