CS4392(2002) View Datasheet(PDF) - Cirrus Logic
Part Name
Description
MFG CO.
CS4392 Datasheet PDF : 42 Pages
| |||
CS4392
4.0.3 SPI Mode
In SPI mode, data is clocked into the serial control data line, CDIN, by the serial control port clock,
CCLK (see Figure 9 for the clock to data relationship). There is no AD0 pin. Pin CS is the chip
select signal and is used to control SPI writes to the control port. When the device detects a high to
low transition on the AD0/CS pin after power-up, SPI mode will be selected. All signals are inputs
and data is clocked in on the rising edge of CCLK.
4.0.3a SPI Write
To write to the device, follow the procedure below while adhering to the control port
Switching Specifications in section 7.
1) Bring CS low.
2) The address byte on the CDIN pin must then be 00100000.
3) Write to the memory address pointer, MAP. This byte points to the register to be written.
4) Write the desired data to the register pointed to by the MAP.
5) If the INCR bit (see section 4.0.1) is set to 1, repeat the previous step until all the desired
registers are written, then bring CS high.
6) If the INCR bit is set to 0 and further SPI writes to other registers are desired, it is nec-
essary to bring CS high, and follow the procedure detailed from step 1. If no further writes
to other registers are desired, bring CS high.
CS
CCLK
CDIN
C H IP
ADDRESS
0010000
MAP DATA 00 00 00 00
R/W
MSB
LSB
byte 1 byte n
M A P = M em ory A ddress Pointe r
Figure 9. Control Port Timing, SPI mode
4.1 Memory Address Pointer (MAP)
7
INCR
0
6
Reserved
0
5
Reserved
0
4
Reserved
0
3
MAP3
0
2
MAP2
0
1
MAP1
0
0
MAP0
0
4.1.1 INCR (AUTO MAP INCREMENT ENABLE)
Default = ‘0’
0 - Disabled, the MAP will stay constant for successive writes
1 - Enabled, the MAP will auto increment after each byte is written, allowing block reads or
writes of successive registers
4.1.2 MAP3-0 (MEMORY ADDRESS POINTER)
Default = ‘0000’
16
DS459PP2
Share Link: 