datasheetbank_Logo     Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

P/N + Description + Content Search

Search Words :

Part Name(s) : APU3048 APU3048M APU3048O U3048 U3048M U3048O A-POWER
Advanced Power Electronics Corp
Description : DUAL SYNCHRONOUS PWM Controller CIRCUITRY AND LDO Controller View

DESCRIPTION
The APU3048 IC combines a Dual synchronous Buck Controller and a linear regulator Controller, providing a cost-effective, high performance and flexible solution for multi-output applICations. The Dual synchronous Controller is configured as 2-independent PWM Controller.
APU3048 provides a separate adjustable output by driving a switch as a linear regulator.

FEATURES
Dual Synchronous Controller in 16-Pin Package with 1808 out-of-phase operation
LDO Controller with 40mA drive
Configured as 2-Independent PWM Controller
Flexible, Same or Separate Supply Operation
Operation from 4V to 25V Input
Internal 200KHz Oscillator
Soft-Start controls all outputs
Fixed Frequency Voltage Mode
500mA Peak Output Drive Capability
Programmable Outputs
RoHS Compliant

APPLICATIONS
DDR Memory Source Sink Vtt ApplICation
GraphIC Card
Hard Disk Drive
Power supplies requiring multiple outputs

 

Part Name(s) : RT9228CS Richtek
Richtek Technology
Description : Advanced PWM and Dual Linear Power Controller View

General Description
The RT9228 is a 3-in-one power Controller optimized for high-performance mICroprocessor and computer applICations. The IC integrates a synchronous buck PWM Controller, a linear regulator, and a linear Controller as well as monitoring and protection functions into a 24-pin SOP package. The PWM Controller regulates the mICroprocessor core voltage. The linear regulator provides power for the clock driver circuit and the linear Controller regulates power for the GTL bus.

Features
3-in-one Regulated Voltages for MICroprocessor Core, Clock, and GTL
Compatible with HIP6018B
Power-good Output Voltage Monitor

Part Name(s) : AN-8027 FCP20N60S Fairchild
Fairchild Semiconductor
Description : FAN480X PFC+PWM Combination Controller ApplICation View

Introduction
This applICation note describes step-by-step design considerations for a power supply using the FAN480X Controller. The FAN480X combines a PFC Controller and a PWM Controller. The PFC Controller employs average current mode control for Continuous Conduction Mode (CCM) boost converter in the front end. The PWM Controller can be used in either current mode or voltage mode for the downstream converter. In voltage mode, feed-forward from the PFC output bus can be used to improve the line transient response of PWM stage. In either mode, the PWM stage uses conventional trailingedge duty cycle modulation, while the PFC uses leadingedge modulation. This proprietary leading/trailing-edge modulation technique can signifICantly reduce the ripple current of the PFC output capacitor.

Part Name(s) : DLI4060B ETC
Unspecified
Description : DLOGIXS SOP24 View

Features

>85% effICiency

- Supports multi Channel System

- 1Ω ~ 8Ω drive capability

- Flat response 20Hz ~ 20Khz - Sets Bridge

- Full Range Amp (250W/4Ω )

- Sub Woofer Amp (850W/1Ω) ApplICation

- Car audio - Home theater - DVD players

- Wireless speakers - Sub woofer system - PDP TV & HDTV - PA Amp

 

Reference site : PWM-dli4060b-IC.html" target="_blank">//www.diyaudio.com/forums/car-audio/200557-crossfire-xp600d-need-PWM-dli4060b-IC.html


Part Name(s) : US3036 US3036CS Unisem
Unisem
Description : 8 PIN PWM SWITCHER Controller IC View

DESCRIPTION
The US3036 IC provides an 8 pin low cost switching Controller with true short circuit protection all in a compact 8 pin surface mount package, providing a low cost switching solution for applICations that require a simple switching regulator from the 5V input where there is no other supply available. One type of such applICation is generating 2.5V standby from the dual 5V(5V and 5V standby) for the next generation processors.
   
FEATURES
■ 8 pin SOIC Switching Controller with
    HICCUP Current Limiting Reduces Diode Power
    Dissipation to Less than 1% of Normal Operation
■ Soft Start Capacitor allows for smooth Output
    Voltage ramp up
■ On board MOSFET driver
■ Fastest transient response of any Controller
    method. ( 0 to 100% Duty Cycle in 100 nS )
■ 1% internal voltage reference
■ Internal Under Voltage Lockout protects
    MOSFET during start-up
   
APPLICATIONS
■ Single input Switching Regulators such as Simple
    5V to 2.5V switcher for RDRAM regulator
   

Part Name(s) : ML4819 ML4819CP ML4819CS Fairchild
Fairchild Semiconductor
Description : Power Factor and PWM Controller “Combo” View

GENERAL DESCRIPTION
The ML4819 is a complete boost mode Power factor Controller (PFC) whICh also contains a PWM Controller. The PFC circuit is similar to the ML4812 while the PWM Controller can be used for current or voltage mode control for a second stage converter. Since the PWM and PFC circuits share the same oscillator, synchronization of the two stages is inherent. The outputs of the Controller IC provide high current (>1A peak) and high slew rate to quICkly charge and discharge MOSFET gates. Special care has been taken in the design of the ML4819 to increase system noise immunity.

FEATURES
■ Two 1A peak current totem-pole output drivers
■ Precision buffered 5V reference (±1%)
■ Large oscillator amplitude for better noise immunity
■ Precision duty cycle limit for PWM section
■ Current input gain modulator improves noise immunity
■ Programmable Ramp Compensation circuit
■ Over-Voltage comparator helps prevent output “runaway”
■ Wide common mode range in current sense compensators for better noise immunity
■ Under-Voltage Lockout circuit with 6V hysteresis

Part Name(s) : US3034 US3034CS Unisem
Unisem
Description : 8 PIN PWM SWITCHER Controller IC View

DESCRIPTION
The US3034 IC provides an 8 pin low cost switching Controller with true short circuit protection all in a compact 8 pin surface mount package, providing a low cost switching solution for dual supply processor applICations that require switching regulator for the 3.3V supply such as the applICations with AGP on board.
   
FEATURES
■ 8 pin SOIC Switching Controller with
    HICCUP Current Limiting Reduces Diode
    Power Dissipation to Less than 1% of Normal
    Operation
■ Soft Start Capacitor allows for smooth Output
    Voltage ramp up
■ On board MOSFET driver
■ Fastest transient response of any Controller
    method. ( 0 to 100% Duty Cycle in 100 nS )
■ 1% internal voltage reference
■ Internal Under Voltage Lockout protects
    MOSFET during start-up
   
APPLICATIONS
■ Dual supply low voltage processor applICations,
    such as: P55Cä,CYRIX M2ä, POWER PCä and
    AMD K6ä
■ Simple 5V to 3.3V switcher for Pentium with AGP
    or Pentium IIä applICations
   

Part Name(s) : ML4819CP ML4819CS ML4819 Micro-Linear
Micro Linear Corporation
Description : Power Factor and PWM Controller “Combo” View

GENERAL DESCRIPTION
The ML4819 is a complete boost mode Power factor Controller (PFC) whICh also contains a PWM Controller. The PFC circuit is similar to the ML4812 while the PWM Controller can be used for current or voltage mode control for a second stage converter. Since the PWM and PFC circuits share the same oscillator, synchronization of the two stages is inherent. The outputs of the Controller IC provide high current (>1A peak) and high slew rate to quICkly charge and discharge MOSFET gates. Special care has been taken in the design of the ML4819 to increase system noise immunity.

FEATURES
■ Two 1A peak current totem-pole output drivers
■ Precision buffered 5V reference (±1%)
■ Large oscillator amplitude for better noise immunity
■ Precision duty cycle limit for PWM section
■ Current input gain modulator improves noise immunity
■ Programmable Ramp Compensation circuit
■ Over-Voltage comparator helps prevent output “runaway”
■ Wide common mode range in current sense compensators for better noise immunity
■ Under-Voltage Lockout circuit with 6V hysteresis

Part Name(s) : APU3046 APU3046O A-POWER
Advanced Power Electronics Corp
Description : DUAL SYNCHRONOUS PWM Controller WITH CURRENT SHARING CIRCUITRY AND LDO Controller View

DESCRIPTION
The APU3046 IC combines a Dual synchronous Buck Controller and a linear regulator Controller, providing a cost-effective, high performance and flexible solution for multi-output applICations. The Dual synchronous Controller can be configured as 2-independent or 2-phase Controller. In 2-phase configuration, the APU3046 provides a programmable current sharing whICh is ideal when the output power exceeds any single input power budget.
   
FEATURES
■ Dual Synchronous Controller in 24-Pin Package
    with 1808 out-of-phase operation
■ LDO Controller with Independent Bias Supply
■ Can be configured as 2-Independent or 2-Phase
    PWM Controller
■ Programmable Current Sharing in 2-Phase Configuration
■ Flexible, Same or Separate Supply Operation
■ Operation from 4V to 25V Input
■ Programmable Switching Frequency up to 400KHz
■ Soft-Start controls all outputs
■ Precision Reference Voltage Available
■ 500mA Peak Output Drive Capability
■ Short Circuit Protection for all outputs
■ Power Good Output
■ Synchronizable with External Clock
■ RoHS Compliant
   
APPLICATIONS
■ Dual-Phase Power Supply
■ DDR Memory Source Sink Vtt ApplICation
■ GraphIC Card
■ Hard Disk Drive
■ Power supplies requiring multiple outputs
   

1

2345678910 Next

All Rights Reserved © datasheetbank.com 2014 - 2020 [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]