datasheetbank_Logo     Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

P/N + Description + Content Search

Search Words :

Part Name(s) : ID245P01 Sharp
Sharp Electronics
Description : 32MB Flash Memory Card View

32MB Flash Memory Card

Part Name(s) : PLL103-06 PLL103-06XC PLL103-06XI PLL103-06XM PLL
PhaseLink Corporation
Description : DDR SDRAM Buffer with 2 DDR or 3 SDRAM DIMMS View

DESCRIPTIONS
The PLL103-06 is designed as a 3.3V/2.5V buffer to distribute high-speed clocks in PC applications. The device has 12 outputs. These outputs can be configured to support 3 unbuffered standard SDR (Single Data Rate) DIMMS and 2 DDR DIMMS. The PLL103-06 can be used in conjunction with the PLL202-04 or similar clock synthesizer for the VIA Pro 266 chipset.

FEATURES
• Generates 12-output buffers from one input.
• Supports up to 2 DDR DIMMS or 3 SDRAM DIMMS.
• Supports 266MHz DDR SDRAM.
• One additional output for feedback.
• Less than 5ns delay.
• Skew between any outputs is less than 100 ps.
• 2.5V or 3.3V Supply range.
• Enhanced DDR and SDRAM Output Drive selected by I2C.
• Available in 28 pin SSOP.

Part Name(s) : HYS64V2100GU-10 HYS72V2100GU-10 HYS64V2100GCU-10 HYS72V2100GCU-10 Siemens
Siemens AG
Description : 3.3V 2M x 64-Bit SDRAM Module 3.3V 2M x 72-Bit SDRAM Module View

3.3V 2M x 64-Bit SDRAM Module
3.3V 2M x 72-Bit SDRAM Module
168 pin unbuffered DIMM Modules

The HYS64(72)V21)00G(C)U-10 are industry standard 168-pin 8-byte Dual in-line Memory Modules (DIMMs) which are organised as 2M x 64 and 2M x 72 high speed memory arrays designed with Synchronous DRAMs (SDRAMs) for non-parity and ECC applications. The DIMMs use eight 2M x 8 SDRAMs for the 2M x 64 organisation and an additional SDRAM for the 2M x 72 organisation. Decoupling capacitors are mounted on the PC board.

• 168 Pin JEDEC Standard, Unbuffered 8 Byte Dual-In-Line SDRAM Module for PC main memory applications
• 1 bank 2M x 64, 2M x 72 organisation
• Optimized for byte-write non-parity or ECC applications
• Fully PC66 layout compatible
• JEDEC standard Synchronous DRAMs (SDRAM)
• Performance:
• Single +3.3V(± 0.3V ) power supply
• Programmable CAS Latency, Burst Length and Wrap Sequence (Sequential & Interleave)
• Auto Refresh (CBR) and Self Refresh
• Decoupling capacitors mounted on substrate
• All inputs, outputs are LVTTL compatible
• Serial Presence Detect with E2PROM
• Utilizes eight / nine 2M x 8 SDRAMs in TSOPII-44 packages
• 4096 refresh cycles every 64 ms
• Gold contact pad
• Card Size: 133,35mm x 29,21mm x 3,00mm for HYS64/72V2100GU
• HYS64/72V2100GCU in chip-on-board technique
• Card Size : 133,35mm x 25,40mm x 3,00mm for HYS64/72V2100GCU

Part Name(s) : ICS93725 ICS93725YFT ICST
Integrated Circuit Systems
Description : DDR and SDRAM Zero Delay Buffer View

Product Description/Features:
• Low skew, Zero Delay Buffer
• 1 to 13 SDRAM PC133 clock distribution
• 1 to 6 pairs of DDR clock distribution
• I2C for functional and output control
• Separate feedback path for both memory mode to adjust synchronization.
• Supports up to 2 DDR DIMMs or 3 SDRAM DIMMs
• Frequency support for up to 200MHz
• Individual I2C clock stop for power mananagement
• CMOS level control signal input

Recommended Application:
    DDR & SDRAM Zero Delay Buffer for SIS 635/640/645/650 & 735/740/746 style chipsets.


Part Name(s) : V380SDC V380SDC-75REVA0 QuickLogic
QuickLogic Corporation
Description : High Performance SDRAM Controller for 32-bit and 64-bit Embedded Processors View

The V380SDC High Performance SDRAM Controller provides all aspects of SDRAM control for high performance embedded systems. The V380SDC enables system designers to replace many lower integration support components with a single, high-integration device. This saves design time, board space, and manufacturing cost.
The V380SDC from V3 Semiconductor provides the necessary (Enhanced) SDRAM access protocol and bus timing resources to work with the latest (E)SDRAM devices. The processor interface on the V380SDC implements the bus protocol of many popular RISC CPUs (AM29030/40, PowerPC 401 Gx, IDT 79RC32364, i960 Cx/Hx/Jx/Rx/Vx, M68040, 68K/ColdFire, PowerPC 750/60x). The V380SDC is also fully compatible with the EPC family of PCI bridges available from V3 Semiconductor.

Part Name(s) : W83178S Winbond
Winbond
Description : 100 MHZ 3-DIMM SDRAM BUFFER View

GENERAL DESCRIPTION
The W83178S is a 13 outputs SDRAM clock buffer for 3-DIMMs models incorporate with W83196S-14 which is the clock synthesizer especially for the 100 MHz models such as Intel BX chipsets. (Refer the datasheet fo Winbond W83196S-14)

FEATURES
· Supports Intel Pentium II CPUs for BX chipset
· 13 SDRAM clocks for 3-DIMMs
· Clock skew less than 250 pS
· Almost none delay Buffer-in controlling SDRAM clocks(<4 nS propagation delay)
· I2C 2-wire serial interface
· Programmable registers to enable/stop each output
· Incorporate with W83196S-14
· Packagedin 28-pin SOP

Part Name(s) : EBD11UD8ABFB EBD11UD8ABFB-6B EBD11UD8ABFB-7A EBD11UD8ABFB-7B EBD11UD8ABFB-6A Elpida
Elpida Memory, Inc
Description : 1GB Unbuffered DDR SDRAM DIMM View

Description
The EBD11UD8ABFB is 128M words ×64 bits, 2 banks Double Data Rate (DDR) SDRAM unbuffered
module, mounted 16 pieces of 512M bits DDR SDRAM sealed in TSOP package.

 

Part Name(s) : HYS64V8000GU-10 HYS72V8000GU-10 Infineon
Infineon Technologies
Description : 3.3V 8M x 64-Bit SDRAM Module 3.3V 8M x 72-Bit SDRAM Module View

The HYS64(72)V8000GU-10 are industry standard 168-pin 8-byte Dual in-line Memory Modules (DIMMs) which are organised as 8M x 64 and 8M x 72 high speed memory arrays designed with Synchronous DRAMs (SDRAMs) for non-parity and ECC applications. The DIMMs use eight 8M x 8 SDRAMs for the 8M x 64 organisation and an additional SDRAM for the 8M x 72 organisation. Decoupling capacitors are mounted on the PC board.

168 pin unbuffered DIMM Modules

• 168 Pin JEDEC Standard, Unbuffered 8 Byte Dual-In-Line SDRAM Modules for PC main memory applications
• 1 bank 8M x 64, 8M x 72 organisation
• Optimized for byte-write non-parity or ECC applications
• Fully PC66 layout compatible
• JEDEC standard Synchronous DRAMs (SDRAM)
• Performance:
• Single +3.3V(± 0.3V ) power supply
• Programmable CAS Latency, Burst Length and Wrap Sequence (Sequential & Interleave)
• Auto Refresh (CBR) and Self Refresh
• Decoupling capacitors mounted on substrate
• All inputs, outputs are LVTTL compatible
• Serial Presence Detect with E2PROM
• Utilizes eight / nine 8M x 8 SDRAMs in TSOPII-54 packages
• 4096 refresh cycles every 64 ms
• Gold contact pad
• Card Size: 133,35mm x 25,40mm x 4,00 mm

Part Name(s) : HYS64V8000GU-10 HYS72V8000GU-10 Siemens
Siemens AG
Description : 3.3V 8M x 64-Bit SDRAM Module 3.3V 8M x 72-Bit SDRAM Module View

The HYS64(72)V8000GU-10 are industry standard 168-pin 8-byte Dual in-line Memory Modules (DIMMs) which are organised as 8M x 64 and 8M x 72 high speed memory arrays designed with Synchronous DRAMs (SDRAMs) for non-parity and ECC applications. The DIMMs use eight 8M x 8 SDRAMs for the 8M x 64 organisation and an additional SDRAM for the 8M x 72 organisation. Decoupling capacitors are mounted on the PC board.

168 pin unbuffered DIMM Modules

• 168 Pin JEDEC Standard, Unbuffered 8 Byte Dual-In-Line SDRAM Modules for PC main memory applications
• 1 bank 8M x 64, 8M x 72 organisation
• Optimized for byte-write non-parity or ECC applications
• Fully PC66 layout compatible
• JEDEC standard Synchronous DRAMs (SDRAM)
• Performance:
• Single +3.3V(± 0.3V ) power supply
• Programmable CAS Latency, Burst Length and Wrap Sequence (Sequential & Interleave)
• Auto Refresh (CBR) and Self Refresh
• Decoupling capacitors mounted on substrate
• All inputs, outputs are LVTTL compatible
• Serial Presence Detect with E2PROM
• Utilizes eight / nine 8M x 8 SDRAMs in TSOPII-54 packages
• 4096 refresh cycles every 64 ms
• Gold contact pad
• Card Size: 133,35mm x 25,40mm x 4,00 mm

1

2345678910 Next

All Rights Reserved © datasheetbank.com 2014 - 2020 [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]